Home / 3D Printing Processes / Scientists Create 3D Printed Photoresponsive Blooming Flower

Scientists Create 3D Printed Photoresponsive Blooming Flower

As reported by Chemistry World, scientists have created a photoresponsive device using shape memory composites.

Combining 3D printing, a shape memory composite and photoresponsive substances, chemists have created a beautiful flower that blooms when exposed to light. This material could bring new opportunities for the development of smart biomimetic devices and soft robotics.

Stimuli-responsive 3D printed devices are quite scarce due to the lack of ‘printable’ functional materials. Moreover, most of these devices respond to temperature changes, and very few are able to react to other stimuli like humidity, chemical changes or light. Now, a team led by Xiaodong Chen, a materials scientist at Nanyang Technological University in Singapore, created a modified polyurethane that shows shape memory and recovers its original shape when illuminated.

They used polyurethane because of its shape recovery ability, then mixed it with small amounts of carbon black to make it light responsive. When illuminated, carbon black generates heat, which is the activator for the polymer’s shape recovery. To demonstrate the composite’s memory response, researchers created a 3D printed sunflower that mimics the natural heliotropism of this family of plants. The photoresponsive sunflower blooms in less than 5 minutes when exposed to either sunlight or a xenon lamp.

Luminous triggers have attracted the interest of the researchers because of their huge versatility: they’re fast, can be easily and accurately focused and can be remotely activated.

Compared with traditional stimuli-responsive devices with simple planar or tubular geometries, 3D printed stimuli-responsive devices not only intimately meet the requirement of complicated shapes at macrolevel but also satisfy various conformation changes triggered by external stimuli at the microscopic scale. However, their development is limited by the lack of 3D printing functional materials.  External illumination triggers the shape recovery of 3D printed devices from the temporary shape to the original shape. The effect of materials thickness and light density on the shape memory behavior of 3D printed devices is quantified and calculated. Remarkably, sunlight also triggers the shape memory behavior of these 3D printed devices. This facile printing strategy would provide tremendous opportunities for the design and fabrication of biomimetic smart devices and soft robotics.

About Anthony Lowder

Check Also

RegoLight Project Uses Sunlight Sintering to 3D Print with Simulated Lunar Regolith

Using the sintering process, the RegoLight team seeks to design and produce a single ‘building element;’ made …

Leave a Reply

Your email address will not be published. Required fields are marked *